Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
SETTING UP
Connecting and turning on your new TV
To conserve energy it is best to turn your TV off and not to leave it in Standby, unless the timer has been set.
The TV back connections�
Connect the aerial to the socket on the rear of the television. If you use a Set Top Box and/or a video recorder it is essential that the aerial cable is connected through the Set Top Box and/or through the video recorder to the television. DO NOT CONNECT SCART LEADS UNTIL THE TELEVISION IS FULLY TUNED.
the back of your TV
AERIAL
� *a SET TOP BOX could be:
nalogue Digital Satellite, A Satellite, or any other compatible decoder.
SET TOP BOX*
VIDEO RECORDER
AERIAL CABLE
AERIAL CABLE
�and switching your new TV on�
On the front of the TV�
O
N
N
If the red power-on light is unlit, press the POWER button on the front of the TV to switch the set on and then press a number button on the remote control to see the screen. �and with the remote control:
RED = Power On GREEN = On Timer is set ORANGE = Bilingual transmission being received GREEN = Stereo transmission being received
Press the Standby Button This allows you to put the set into standby mode when leaving the TV unattended for short periods of time. To return to TV mode press the button, or any of the numbered buttons on
i:
i
the remote control. The picture may take a few seconds to appear.
